#Logitech webcam c270 how to#

In addition to the 3D printed mount itself, I need:Р”Р‡irst, I added a washer to the M3 bolt and inserted it through the cameraРІР‚в„ўs mounting point, through the support arm on the 3D printed mount, and then secured it with a second washer and a nut. The part was sliced in Cura 4.3.0 and took only about 30 minutes to print. And I kind-of want this mount to be more subtle than that. I could have just as well printed this out of PLA, but I donРІР‚в„ўt have any PLA on hand that isnРІР‚в„ўt electric pink. IРІР‚в„ўm using 1.75 mm Hatchbox ABS filament, which prints quite nicely even though I donРІР‚в„ўt have an enclosed printer. The final mount was printed out of black ABS on my Printrbot Simple Metal with 25% infill at a layer height of 0.15 mm. I then exported the STL file for printing. Then I filleted all of the edges for strength and to make this easier to print. Since the camera was going to snug up against these ribs when tilted downwards, I used a profile gauge to measure the curvature of the camera, scanned the result, scaled it to size, and then used that to match the rib geometry to cradle the camera.Р”Р‡inally I created a hole through the center of the part for the M4 bolt thatРІР‚в„ўs going to mount this to the aluminum extrusion. This arm was also offset from the mount centerline so that the camera body sits over the middle of the mount.Р”В«ack on the main body of the mount, I added some ribs to either side to give the mount some stiffness and prevent the camera from tilting all the way down into the extrusionРІР‚в„ўs mounting screw. These offsets were just eyeballed based on what looked right.

From there I created a supporting arm going up to the cameraРІР‚в„ўs pivot point, offset away from the base to allow the camera to pivot and to provide clearance for the mounting hardware. To start, I created a simple rectangular base thatРІР‚в„ўs slightly smaller than the 20 mm extrusion to avoid interference with other parts. Now that we know what the mounting point of the camera looks like, itРІР‚в„ўs time to do the 3D design for the mount. This needs to stay in place in order to make the new attachment bolt fit snugly. Note that inside of this pivot is a small white sleeve bearing. With the original mount removed we can measure the mounting/pivot point on the back of the camera to make the new part. After removing the screw, the pin can be pushed out with a screwdriver and the mount will fall off. These can be pried up with a small flat-head screwdriver, revealing a tiny Phillips-head screw holding the assembly in place.

On either side of the pivot point there are two rubber discs.

#Logitech webcam c270 how to#

That means the first step of this process is to take apart the monitor mount that comes with the webcam and figure out how to attach to the camera directly. Unlike some of LogitechРІР‚в„ўs nicer webcams like the ubiquitous C920, the C270 doesnРІР‚в„ўt have a 1/4-20 mounting point on it to attach a regular tripod.